K+ 3D Printed Flying wing FPV Drone

In this project, the objective was to build a FPV flying wing with over 700mm wingspan that could be printed under 24 hours at 0.2mm layer height and is easily Assembled. The drone comprise of only 8 parts. You do not need a flight controller or anything else to run FPV on this model.

3D Printed Parts
-2 Elevons
-2 Wing Tips
-2 Wings
-1 Fuselage
-1 Canopy

Electronics
- 2 x Servos Motor 9g https://amzn.to/3H0UXK0
- A2212 Motor (1000kv or 2000kv) https://amzn.to/3xfTElX
- 1 x 30 Amps ESC https://amzn.to/3xmMmxV
-Micro FPV Camera Kit (with transmitter and receiver) https://amzn.to/3GW10zj
-RC Transmitter/Receiver https://amzn.to/3Mw279T
-6045 Propeller https://amzn.to/3mkzVfR

Tools
-3D Printer (With one Axis larger than 250mm) https://amzn.to/3NvBZxe
-Hot glue Gun & Sticks https://amzn.to/3NXmv5c
-Cyanoacrylate glue https://amzn.to/3aAUoKo
-RC elevon rods https://amzn.to/3MkCY24

Checkout Build Video at: https://youtu.be/7MNrspOFYNY

3D PRINTING SETTINGS

0.2mm layer height

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×