In this project, the objective was to build a FPV flying wing with over 700mm wingspan that could be printed under 24 hours at 0.2mm layer height and is easily Assembled. The drone comprise of only 8 parts. You do not need a flight controller or anything else to run FPV on this model.
3D Printed Parts
-2 Elevons
-2 Wing Tips
-2 Wings
-1 Fuselage
-1 Canopy
Electronics
- 2 x Servos Motor 9g https://amzn.to/3H0UXK0
- A2212 Motor (1000kv or 2000kv) https://amzn.to/3xfTElX
- 1 x 30 Amps ESC https://amzn.to/3xmMmxV
-Micro FPV Camera Kit (with transmitter and receiver) https://amzn.to/3GW10zj
-RC Transmitter/Receiver https://amzn.to/3Mw279T
-6045 Propeller https://amzn.to/3mkzVfR
Tools
-3D Printer (With one Axis larger than 250mm) https://amzn.to/3NvBZxe
-Hot glue Gun & Sticks https://amzn.to/3NXmv5c
-Cyanoacrylate glue https://amzn.to/3aAUoKo
-RC elevon rods https://amzn.to/3MkCY24
Checkout Build Video at: https://youtu.be/7MNrspOFYNY
3D PRINTING SETTINGS
0.2mm layer height